Datoptic ARC-1680 Series Manual do Utilizador descarregar pdf (Página 99)

DRIVER INSTALLATION

Note:

The computer system BIOS must support bootable from CD-

ROM.

volume set is created and congured, continue with next step to

install the operating system.

3. Insert the Windows setup CD and reboot the system to begin

the Windows installation.

4. Press F6 as soon as the Windows screen shows ”Setup is

inspecting your computer’s hardware conguration”. A mes-

sage stating “Press F6 to specify thrid-party RAID controller” will

display during this time. This must be done or else the Windows

installer will not prompt for the driver from the SAS RAID con-

troller and the driver diskette will not be recognized.

5. The next screen will show: “Setup could not determine the

type of one or more mass storage device installed in your sys-

tem. ”Selected “specify additional SCSI controller” by pressing

6. Window will prompt to place the “Manufacturer-supplied

hardware support disk” into oppy drive A:. Insert the SAS RAID

series driver diskette in drive “A:” and press Enter key.

7. Window will check the oppy; select the correct card and CPU

type for your hardware from the listing and press Enter key to

install it.

8. After Windows scans the hardware and nds the controller, it

will display:

“Setup will load support for the following mass storage devices:”

“ARECA[Windows X86-64 Storport] SATA/SAS PCI RAID Host

Controller(RAID6-Engine Inside)”. Press Enter key to continue

and copy the driver les. From this point on, simply follow the

Microsoft Windows installation procedure. Follow the on-screen

instructions, responding as needed, to complete the installation.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 183 184

Sem comentários

Datoptic ARC-1680 Series Manual do Utilizador Página 99